Accessories/Electrodes

This is by far the most wide subject to discuss in relation to E-Stim. It is arguably the most important part of any setup. I will refer to all accessories as electrodes. Generally, electrodes can be anything that is a good conductor of electricity. My personal favorite is copper pipe. Copper is the second most conductive metal that is available, and it is definantly cheaper than silver, which is #1. Copper pipe is readily available in dozens of sizes, lengths, and maliablilities. I specialize in electrodes for the specific purpose of producing pleasure to the penis. The easiest and most effective setup for getting a penis pleasure is a copper pipe conversion coupler and a copper pipe cut to an appropriate length. The size of these electrodes will be based on the size of your penis. The best way to figure out what sizes you will need is to get a string or ribbon, or something that is very flexible, and use it to measure the circumference of your penis at specific locations. For the tube to go around the base of your penis, you should measure the circumference at the base, at 1 inch up, and at 2 inches up. The circumference that you choose to be the size of your pipe should be determined by how tight you want the pipe to be around your penis. If you want a relaxed fit, use the measurment at the base. If you want a 'hugging' fit, then you should use the measurment at 1 inch up (my recommendation). If you want a constrictive fit, then you should use the measurment at 2 inches up. To convert the circumference to the diameter, divide the circumference by pi (3.14159). Now, the sizes available at your local hardware store might not be exactly your measured diameter, but use your discression to pick a size. You will also need a saw of some kind to cut the pipe down to size. You will want to cut several sizes, I reccommend a 3", a 2", and a 1". That is your penis base electrode, to get your head electrode, measure and calculate the diameter of your penis just below the head, right as the head begins (at the 'bulge'), and at the tip. You want to find a copper pipe compression adapter that goes from around the size of the measurement at the bulge to the measurement right near the tip. For an average person, you will need either a 1" to 3/4" conversion coupler or a 3/4" to 1/2" coupler. With these two electrodes, you are ready to connect it to the reciever. There will be countless other posts on other forms of electrodes. But these are the basics, or essentials.